Heated Filter/Valves
Atmo-Seal Engineering, Inc. manufactures custom
heated components for use in gas and
diesel sampling; stack and process monitoring, dispense, freeze protection and
other area required by our customers, We also combine components,
manifolds, pumps, filters and prefabricated tubes into specific heated devices
which fit your exact needs. And all Atmo-Seal components easily interface with
our heated sample lines.
Pictured below are a few examples of our custom-heaters and components.
Heated Bayonet-Type
Filter and Solenoid Assembly
- Choice of AC 50-60 HZ or DC operation
in a wide range of voltages
- Choice of Thermocouple, RTD, Internal
Thermostat or other sensors
- Choice of valve configuration (2 way/3 way)
- Solenoids may be located up- or down-
stream of the filter
- Housings are available for common filter
sizes (1 X 7, 1 X 2.5, 1/2 x 2.25, 1/2 x 1")
- Easily dis-assembled and repaired in situ if needed
- Filter element may be changed easily by the user
Click here for Filter/Valve
PDF
The Solenoid Valve and Filter Units are just one
example of how a specific customer need has lead to a standard product. Uses
include multiple sample selection, leak checking, purging and introduction of
calibration gases. They are custom made to your specifications and will route
and filter your sample gas exactly as needed for your application...Just call
us!
Problem Solvers....
Atmo-Seal, Inc. is a "think tank" company. We use our
expertise to create high-quality, cost-effective components and systems to solve
your sampling and dispensing needs.
Heated ball valve and filter combination pictured above. The ball valve is
completely serviceable by simply removing the heated sleeve shown in figure 2.
Available in either single temperature zone or dual temperature zone configurations.
Options
As always, Atmo-Seal, Inc., will customize your
filters to your exacting specifications WITHOUT jeopardizing your delivery
schedule.