Innovative Solutions for HC Hang-Up, Cold Start and Steady State testing...
Direct Couple Heated Line
- Choice of AC 50-60 HZ or DC operation
in a wide range of voltages
- Choice of Thermocouple, RTD, Internal
Thermostat or other sensors
- All stainless steel wetted parts
- Warms your incoming sample during cold start - Cools your sample down to a
workable temp
during extended test cycles
- Protects expensive downstream
components
from damage due to excessive heat
Used in virtually all emissions
testing situations for gasoline engine and diesel engine development. Used for diesel engine certification and on-road testing.
Tough, Accurate Heated Lines
Atmo-Seal, Inc. prides
itself on innovation and problem solving. The problem: Incoming sample gas that
starts out cold and rises to unacceptable levels during the test cycle. When the
sample is cold, moisture and Hydrocarbon hang up affect the accuracy of your data. When
the sample is over-heated, expensive equipment is damaged and the test halted.
Atmo-Seal’s answer is the Direct Coupling Heated Sample Line.
A high-watt, extreme temperature heating circuit ensures a quick, stable heat of
your emissions sample. When the emissions sample temperature rises, this non-insulated tube lets
heat easily escape, lowering your sample temperature. The outer sleeve, length
and surface area of the tube of the hose work together passively to wisk away
heat more efficiently than a plain sample tube.
Our Direct Couple Heated Line is much less expensive than a heated filter or
sample line. This allows it to be treated as a “sacrificial lamb” saving your
downstream components.
When it comes to innovation in the test cell, ASE has got you covered.